• No loss at SAT-range
• High modulation / high signal-quality
• Low power consumption
• Short-circuit proof
• Made in Germany

 
 Usage
 Multiswitch HSATS516ER distributes the signals of your satellite system to up to 16 devices (satellite receiver, TV sets with satellite tuner, etc.).The HSATS516ER has a built-in 22 kHz generator and can be used with a Quattro or Quad LNB. Using a Quattro LNB, make sure that vertical/horizontal and low/high band signals are connected correct. The 4 outputs of the Quad LNB can be connected to any Sat input of the switch. The terrestrial input is designed for using with a DVB-T / FM antenna.
 
 Safety Instructions
 Please check first the coaxial cable regarding short circuit before starting!
 The mounting ground should be:
 

• even and flame proof
• dust-free
• protected against humidity
• not under direct impact of sunlight
• not adjacent to heating sources

 
 The ventilation slots of the power supply unit may not be covered. It is to be paid attention to it that the input levels of the SAT-lines are equivalent high.All installation and fixing of components should only be executed when the units are disconnected from the mains supply. Avoid short-circuits. The applicate standards and regulations for the guarantee of electrical security are to be considered. The national regulations for broadcast recording systems have to be observed!
 
 Installation
 First connect the HSATS516ER with all external devices (antennas, receivers, LNB) and do not forget grounding of the device. Use the GND terminal for earth connection. After that you can plug in the power cord into the mains. The indicator next to the GND terminal should lit.